Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.

About Damping (something new)

Please login with a confirmed email address before reporting spam

Hi Everyone,
I started a discussion several days ago about the damping in Electromagnetic Anslysis. Now I just find something new! I used a very simple model(Just mechanic). A polymer bridge and a block of nickel on top of it. I apply 1N(-Z, point down) force uniformly on the nickel. Then I did transient analysis, the bridge (together with nickel block) started to shake then it stopped. It is so wired that I didn't set any energy loss.

That's a very simple model that I can have its static results which means it will stay still finally. So the Comsol is applying some damping factor even you didn't set?

Any one have any idea on that?

Thanks a lot!

Link to previous discussion

www.comsol.com/community/forums/general/thread/920/

1 Reply Last Post 2009年10月7日 GMT+2 14:54
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2009年10月7日 GMT+2 14:54
Hi

I do not beleive its so new ...

have a look at

www.comsol.com/community/forums/general/thread/326/#p758

start to use a search on the forum, there is now quite alot in here, often the same questiosn come up, which does not mean that we cannot continue to go further.

Ivar
Hi I do not beleive its so new ... have a look at http://www.comsol.com/community/forums/general/thread/326/#p758 start to use a search on the forum, there is now quite alot in here, often the same questiosn come up, which does not mean that we cannot continue to go further. Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL®software users who are on-subscription should submit their questions via theSupport Centerfor a more comprehensive response from the Technical Support team.

Baidu
map