Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
customize time stepping or tolerance
Posted 2009年10月15日 GMT+2 00:060 Replies
Please login with a confirmed email address before reporting spam
I structured two Microwave antennas in comsol3.5 and ran it in RF and Heat transfer module. The input power was switching between two antennas (pulsing signal). I scripted this in Matlab. However, it took me such a long time to complete the simple simulation due to the automatically condensed time stepping when power is switching. How can I make it faster? Is there a way to change the tolerance setting to be time dependant(I want to make it bigger at the pulse edge)? Or can I set up time-stepping manually?
Thanks a lot!
Yu
Thanks a lot!
Yu
0 Replies
Last Post 2009年10月15日 GMT+2 00:06
Hello Yu Huang
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.