Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
Revolving Geometry including Properties
Posted 2009年7月8日 GMT+2 16:550 Replies
Please login with a confirmed email address before reporting spam
I have a question concerning the "Revolve"/"Extrude"-function of Comsol. I often set up a part of the model in 2d in order to see if it works. Then I extrude/revolve it into a 3d-geometry and add some features. Unfortunately, I always lose everything I specified in 2d (materials, boundaries, even the application modes etc.). Is it possible to keep the model specified even when it is in 3d instead of 2d?
Regards
David Wenger
Regards
David Wenger
0 Replies
Last Post 2009年7月8日 GMT+2 16:55
Hello David Wenger
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.