Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
Conductive Media DC and Electrostatics
Posted 2009年7月15日 GMT+2 20:280 Replies
Please login with a confirmed email address before reporting spam
Dear all,
I am very new to comsol so I am hoping for a pointer in the right direction
I am working in 3D with the following desired setup:
One cone (insulating properties) in contact with two cubes, one on each side (metallic properties) one cube has a potential of one volt, the other is a ground.
Now here is where I run into my issue is that I also wish to assign a charge density to the cone. From what I have gathered is that you can do this with the Electrostatics model.
So my question is how do I get the surface charge density into the Conductive Media DC model?
Thank you for any help!
~Chris
I am very new to comsol so I am hoping for a pointer in the right direction
I am working in 3D with the following desired setup:
One cone (insulating properties) in contact with two cubes, one on each side (metallic properties) one cube has a potential of one volt, the other is a ground.
Now here is where I run into my issue is that I also wish to assign a charge density to the cone. From what I have gathered is that you can do this with the Electrostatics model.
So my question is how do I get the surface charge density into the Conductive Media DC model?
Thank you for any help!
~Chris
0 Replies
Last Post 2009年7月15日 GMT+2 20:28
Hello Christopher Stiles
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.