Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
inverted mesh problem
Posted 2009年7月20日 GMT+2 23:562 Replies
Please login with a confirmed email address before reporting spam
Hi
I just started learning COMSOL for my project. I am working on plane strain with fluid interaction module and it gives me inverted mesh error again and again. Could someone please tell me how to fix this problem.I would really appreciate any sort of help.
Thank you,
Manohar
I just started learning COMSOL for my project. I am working on plane strain with fluid interaction module and it gives me inverted mesh error again and again. Could someone please tell me how to fix this problem.I would really appreciate any sort of help.
Thank you,
Manohar
2 Replies
Last Post 2009年7月21日 GMT+2 05:30
Please login with a confirmed email address before reporting spam
Posted:
2 decades ago
Hi,
from my understanding, inverted meshing is first of all a severe warning that he reasults may be quite wrong, and not only close to the inducated area, but not in 100% of all cases
.
For me it typically appears when I have not correctly "defeatured" my geometry, that is removed all unecessary small features such as screw holes, fillets, shamfers, badly aligned dxf (a format I hate because its not well defined/normalised, but its the only one really accepted in 2D).
So study your geomtry (and do this in your CAD environment its mostly quicker there), and learn to design in function of the FEM requirements, then add the "small features" for the manufacturing drawings afterwards.
Good luck
Ivar
from my understanding, inverted meshing is first of all a severe warning that he reasults may be quite wrong, and not only close to the inducated area, but not in 100% of all cases
.
For me it typically appears when I have not correctly "defeatured" my geometry, that is removed all unecessary small features such as screw holes, fillets, shamfers, badly aligned dxf (a format I hate because its not well defined/normalised, but its the only one really accepted in 2D).
So study your geomtry (and do this in your CAD environment its mostly quicker there), and learn to design in function of the FEM requirements, then add the "small features" for the manufacturing drawings afterwards.
Good luck
Ivar
Please login with a confirmed email address before reporting spam
Posted:
2 decades ago
Thank you for your advice Mr.Kjelberg I will look into that. That was helpful.