Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.

Wave Optics Module will not Run

Please login with a confirmed email address before reporting spam

I am not able to get this model to run and get Warning message “MUMPS is switching to out-of-core mode”. Also get error message: Failed to find solution. Unable to read o write out-of-core file. I have tried different meshing (normal, fine and custom) but no luck in getting it to run. Could it be a meshing issue or something else.

Best regards, Richard P.S. Running Windows and COMSOL 6.1



1 Reply Last Post 2023年9月25日 GMT+2 20:35
Robert Koslover Certified Consultant

Please login with a confirmed email address before reporting spam

Posted: 11 months ago 2023年9月25日 GMT+2 20:35
Updated: 11 months ago 2023年9月25日 GMT+2 20:25

Switching to out-of-core mode suggests that your problem, as presently configured, is too large for your available RAM. Aside from adjusting the mesh, also consider employing other methods to reduce the required amount of RAM to solve your problem, such as using linear instead of quadratic discretization, and/or employing an interative solver instead of a direct solver.

-------------------
Scientific Applications & Research Associates (SARA) Inc.
www.comsol.com/partners-consultants/certified-consultants/sara
Switching to out-of-core mode suggests that your problem, as presently configured, is too large for your available RAM. Aside from adjusting the mesh, also consider employing other methods to reduce the required amount of RAM to solve your problem, such as using linear instead of quadratic discretization, and/or employing an interative solver instead of a direct solver.

Note that while COMSOL employees may participate in the discussion forum, COMSOL®software users who are on-subscription should submit their questions via theSupport Centerfor a more comprehensive response from the Technical Support team.

Baidu
map