Menu

Discussion Forum

New Discussion
查找

Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.

Study with range of data

Posted 2023年10月18日 GMT+2 19:50Results & Visualization, Studies & Solvers, Modeling WorkflowVersion 5.52 Replies

Odette Beaudin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am trying to model the flow rate of water through a part. I want to change the pressure from 50 - 90 psi in intervals of 10 and then save each result into a report. What is the most efficient way to do this? I am assuming I do not have to create a new study for each interval.

I am very new to comsol so any help is greatly appreciated.

Thanks Odette

2 Replies Last Post 2023年10月19日 GMT+2 00:51
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 10 months ago 2023年10月18日 GMT+2 20:57
Updated: 10 months ago 2023年10月18日 GMT+2 20:57

Hello Odette,

It sounds like what you want to do is a parametric sweep. See theIntroduction to COMSOL Multiphysicsmanual for examples.

Best regards,

Jeff

-------------------
Jeff Hiller
Hello Odette, It sounds like what you want to do is a parametric sweep. See the [Introduction to COMSOL Multiphysics](https://cdn.comsol.com/doc/6.1.0.357/IntroductionToCOMSOLMultiphysics.pdf) manual for examples. Best regards, Jeff
Odette Beaudin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 months ago 2023年10月19日 GMT+2 00:51
Updated: 10 months ago 2023年10月19日 GMT+2 20:25

Thanks Jeff! Another quick question. I want to put a 3D plot group for each interval of the parametric sweep into a report. What is the best way to do this? Currently it seems like I can only add one interval into the report.

Thanks Jeff! Another quick question. I want to put a 3D plot group for each interval of the parametric sweep into a report. What is the best way to do this? Currently it seems like I can only add one interval into the report.

Note that while COMSOL employees may participate in the discussion forum, COMSOL®software users who are on-subscription should submit their questions via theSupport Centerfor a more comprehensive response from the Technical Support team.

Suggested Content

Baidu
map