Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.

How to set maximum substance deposition in electrochemistry module?

Please login with a confirmed email address before reporting spam

I recently read the articleModelling the Molten Salt Electrorefining Process for Spent Metal Fuel Using COMSOL. This article used 'secondary current distribution' and 'transport of the diluted species'.

U and Pu were dissolved from the Cd anode, into the molten salt and deposited at the solid cathode, as shown in Figure 6, where U was fully deposited and Pu began to be deposited at approximately 50h.

The authors seem to have set a maximum amount of U and Pu to be deposited and would like to know how this should be achieved in COMSOL? Thank you all very much!

FIG. 6. Deposition histories of uranium and plutonium on the solid cathode - model validation with experimental data (Citation1).


0 Replies Last Post 2023年11月20日 GMT+1 11:29
COMSOL Moderator

Hello Bill Old

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL®software users who are on-subscription should submit their questions via theSupport Centerfor a more comprehensive response from the Technical Support team.

Baidu
map