Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.

Use results of a simulation as BC input

Please login with a confirmed email address before reporting spam

Hello everybody,

I'm working on a transient 2D simulation representing a cross section of a finned metal component. The finned component is in contact with air, I meshed also the air domain and imposed an inlet temeprature which gradually reduces with the passing of time. The simulation runs well and I get good results.

Now, I would like to use the temperature on some of the boundaries of the metal domain from study 1 as a boundary condition for a second transient study. This temeprature has a distribution in space and changes over time.

I'm not sure on how to proceed after I got the results of the first study, does someone have some suggestion?

Thank you, EP


0 Replies Last Post 2024年1月25日 GMT+1 15:32
COMSOL Moderator

Hello Edoardo Pansoya

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL®software users who are on-subscription should submit their questions via theSupport Centerfor a more comprehensive response from the Technical Support team.

Baidu
map