Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
Boundary current source vs terminal - on internal boundary
Posted 2024年2月13日 GMT+1 21:00General, Results & Visualization, Studies & SolversVersion 6.00 Replies
Please login with a confirmed email address before reporting spam
Hello,
I have a question about the AC/DC module -> Electric currents.
I made a simple model and assigned aterminalboundary condition of 1A in one of the contact surfaces, which is an internal boundary in the model.
When I integrate the total current on the ground that comes very close to 1A.
However, when I replace theterminalwith aboundary current sourceon the same internal boundary and replace 1A with 1A/(area of the contact in sq.m). The resultant electric field is much weaker and the total current on the ground is about 0.1, 10 timess less that what I applied.
I think this is strange because I expect both the conditions to deliver 1A current.
I appreciate any help in pointing out the error in this process.
Hello Aragorn
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.