Stationary analysis heater control

Please login with a confirmed email address before reporting spam

I have a model of an electrically powered radiant heater heating a part. My goal is to determine the heater power and thermal distribution on the part when the part reaches a desired average temperature setpoint. I am not particularly interested in transient behavior at this point.

I can get this to work using a smoothed step function to control the heater power as a function of a temperature probe, but only in a transient analysis run for long enough that everything comes to equilibrium. Trying to use this method with a stationary analysis results in convergence difficulties and unreliable heater power results (for instance, getting zero reported steady state heater power when the heater and part are both hot).

Is there a method to target/solve for heater power level to get my part to the temperature set point in a stationary (steady state) thermal analysis?


0 Replies Last Post 2024年3月14日 GMT+1 20:42
COMSOL Moderator

Hello Lividly7327

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Reply

Please read thediscussion forum rulesbefore posting.

Pleaselog into post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL®software users who are on-subscription should submit their questions via theSupport Centerfor a more comprehensive response from the Technical Support team.

Baidu
map