Low quality mesh is generated when Meshing a Thin film on a thick metal

Please login with a confirmed email address before reporting spam

My model contains a block of 8mm*8mm*0.5mm copper block and coated with a 8mm*8mm*300nm Niobium. I am unable to mesh the model with air boundary. This model was meshed properly with no boundary conditions. Can you help me with a solution to mesh the block with air boundary condition.


0 Replies Last Post 2024年5月8日 GMT+2 08:49
COMSOL Moderator

Hello Namitha Venugopal

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Reply

Please read thediscussion forum rulesbefore posting.

Pleaselog into post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL®software users who are on-subscription should submit their questions via theSupport Centerfor a more comprehensive response from the Technical Support team.

Baidu
map