Layer-adding simulation

Please login with a confirmed email address before reporting spam

Hi. I'm an engineering student trying to model an LBPF-type simulation, where a laser heats a part layer by layer. I was wondering if it is possible to either: 1. Run a simulation for the first layer, then automatically create the geometry, mesh, etc. for the second layer on top of the first layer, run the simulation again, using the temperature distribution at the top of the first layer as one of the boundary conditions for the bottom of the second layer - perhaps using JAVA-scripting? 2. Create a single component including all the layers, and then have all layers except the bottom one turned off (maybe using the activation feature), and as the laser moves upwards, into a new layer, have the new layer turned on, with the temperature distribution at the top of the first layer applied as a boundary condition of the bottom of the second layer.

Or perhaps there is a better method of doing layer-adding simulations?

Best regards, Anton.


0 Replies Last Post 2024年9月12日 GMT+2 17:36
COMSOL Moderator

Hello Anton Thorsen

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Baidu
map