Note: This discussion is about an older version of the COMSOL Multiphysics®software. The information provided may be out of date.
Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
Error after 300 iteration steps
Posted 2013年8月25日 GMT+2 14:04Version 4.3b2 Replies
Please login with a confirmed email address before reporting spam
HI,
I am very new to COMSOL multiphysics.
I am using CFD> non-isothermal to simulation the room temperature.
After 300 iteration steps, I received the error mas at attched.
I shall be very thankful if anyone assist me.
--
Aung Myat
I am very new to COMSOL multiphysics.
I am using CFD> non-isothermal to simulation the room temperature.
After 300 iteration steps, I received the error mas at attched.
I shall be very thankful if anyone assist me.
--
Aung Myat
Attachments:
2 Replies
Last Post 2013年8月26日 GMT+2 03:09
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi,
I am not expert on CFD module, but I guess in your equation you reported here the square root should be different than zero (either because you have a fraction in the sqrt, or because this equation is then used somewhere else). Therefore, try to add in your equation a very small value, let's say 1e-6, both at numerator and at the denominator, to avoid possible singularities.
Bests
I am not expert on CFD module, but I guess in your equation you reported here the square root should be different than zero (either because you have a fraction in the sqrt, or because this equation is then used somewhere else). Therefore, try to add in your equation a very small value, let's say 1e-6, both at numerator and at the denominator, to avoid possible singularities.
Bests
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi fabio,
Thank for the reply. i will try it.
--
Aung Myat
Thank for the reply. i will try it.
--
Aung Myat