Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics®software. The information provided may be out of date.

Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.

half cylinder

Posted 2014年2月13日 GMT+1 16:32Version 4.3b2 Replies

Arshad Salema
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,
Can any one please help me how to draw half cylinder. I mean which is cut exactly in middle i.e. half of the diameter. I had already draw the cylinder, but I do not know how to cut into half.

Thanks.
2 Replies Last Post 2014年2月27日 GMT+1 17:00
Sergei Yushanov Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2014年2月13日 GMT+1 17:36
Arshad,

Attached is half cylinder.

Regards,
Sergei
Arshad, Attached is half cylinder. Regards, Sergei

Attachments:

Arshad Salema
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2014年2月27日 GMT+1 17:00
Thank you very much Sergei.

regards,

Arshad
Thank you very much Sergei. regards, Arshad

Note that while COMSOL employees may participate in the discussion forum, COMSOL®software users who are on-subscription should submit their questions via theSupport Centerfor a more comprehensive response from the Technical Support team.

Suggested Content

Baidu
map