Note: This discussion is about an older version of the COMSOL Multiphysics®software. The information provided may be out of date.
Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
Bending curvature of beam
Posted 2014年3月10日 GMT+1 07:33Structural MechanicsVersion 4.41 Reply
Please login with a confirmed email address before reporting spam
Hello, I have a problem when doing a simulation with a beam bending.
I want to apply the specific radius of curvature to beam.
How to solve the problem by using the boundary condition?
I want to apply the specific radius of curvature to beam.
How to solve the problem by using the boundary condition?
1 Reply
Last Post 2014年3月10日 GMT+1 10:16
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
if you have a regular beam, a moment load will give you a radius of curvature type shape.
Then you can use the new 4.4 "curv" variables, see the help "Geometric Variables and Mesh Variables" to measure the average curvature and drive the moment load until you get the desired value
--
Good luck
Ivar
if you have a regular beam, a moment load will give you a radius of curvature type shape.
Then you can use the new 4.4 "curv" variables, see the help "Geometric Variables and Mesh Variables" to measure the average curvature and drive the moment load until you get the desired value
--
Good luck
Ivar