Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
Solving
Posted 2010年7月20日 GMT+2 22:270 Replies
Please login with a confirmed email address before reporting spam
Hi:
I have a 3D model that runs and solves a parametric sweep without any problems,
but when I run this same model in comsol 4.0 its run but gets stuck in the middle around (Constraint Handling)
What might be the cause of this?
Best Regards
Pekir
I have a 3D model that runs and solves a parametric sweep without any problems,
but when I run this same model in comsol 4.0 its run but gets stuck in the middle around (Constraint Handling)
What might be the cause of this?
Best Regards
Pekir
0 Replies
Last Post 2010年7月20日 GMT+2 22:27
Hello Pekir Joseph
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.